Pages

Saturday, April 14, 2012

Attempting to launch a XenDesktop 5.5 or 5.6 desktop through an NetScaler Access Gateway throws the error: “Unable to launch your application. Contact your help desk with the following information: Cannot connect to the Citrix XenApp server. Protocol Driver error”

Problem

You attempt to launch a XenDesktop 5.5 or 5.6 desktop through an NetScaler VPX Access Gateway but receive the following error message from the Citrix Receiver:

Unable to launch your application. Contact your help desk with the following information: Cannot connect to the Citrix XenApp server.
Protocol Driver error

image

image

Solution

While this error message can be caused by various reasons, the first to check should be the following KB:

Case Study: The Protocol Driver Error is displayed when starting an Application through Access Gateway Enterprise Edition in the ICA Proxy Mode
http://support.citrix.com/article/CTX125718

… to determine whether you have maxed out your concurrent user sessions configured on the Access Gateway as shown in the following:

Access –> Gateway –> Change authentication settings

image

image

image

Note that you can also check to see how many active user sessions there are by navigating to:

Access Gateway –> Active user sessions

image

image

-------------------------------------------------------------------------------------------------------------------------------------------------------------------

I’ve also come across the situation where the NetScaler had no active sessions but was still suing evaluation licenses so when I went ahead to put the permanent licenses on, the error went away.

No comments: